Build your own dog fence – Electric dog fences work with a wire collar. The transmitter and the dog to have a dog within the confines of our field. The electric fence acts as a limit. After the installation of the fence and the transmitter. The collar will skip a beep when the dog approaches the limit. If the dog continues to ignore the signal and approaches the cable. The dog will receive a static discharge from the collar. Earth trenches are dug with a lawn edger or shovel. Fences that are connected to the existing fences are joined with a staple gun. If the wire from the electric fence dog extend beyond concrete. Then, saw and concrete blade are needed to make a trench through the concrete. And then, a silicone sealant is used to seal the trench.
Build your own dog fence, a Phillips-head or Philips screwdriver is used to mount the transmitter. Then, drill and drill of 1/3 inch are used to drill a hole through the wall where the transmitter is located so that the wires can run in the building to the unit. The electric fence wire dog is buried underground about 3 inches. Then the wire is attach to an existing fence with staples to keep the dog away from the fence. The fence wire is run over the top of concrete. And then seal with a silicone sealant to keep the cable in place and protected from the weather. If more wire is needed, the wire should be the same as the wire in the kit. Each end of the cable is connected to the transmitter.
15 Photos Gallery of: Build Your Own Dog Fence Electric
Build your own dog fence, transmitters vary for each manufacturer. and also the transmitters are mounted inside the elements. In areas of extreme cold, the transmitters are mounted in the house on an exterior wall. In areas where temperatures are not extremely cold, the transmitters are mounted in a garage. The transmitters are ground with the socket screw that holds the face plate. Then, connect to a ground connection box that comes with the kit. When the transmitter is activated, it sends signals to the dog collar.